题名: |
COMPARISON OF SUPERPAVE AND MARSHALL MIXTURES FOR LOW-VOLUME ROADS AND SHOULDERS. |
作者: |
Habib-A; Hossain-M; Kaldate-R; Fager-GA |
关键词: |
SUPERPAVE-; MIX-DESIGN; MARSHALL-MIX-DESIGN-METHOD; LOW-VOLUME-ROADS; SHOULDERS-; CRUSHED-LIMESTONE; SANDS-; COARSE-AGGREGATES; FINE-AGGREGATES; GYRATORY-COMPACTOR; HAMMERS-; BULK-DENSITY; SPECIFIC-GRAVITY; ASPHALT-CONTENT; VOIDS-FILLED-WITH-ASPHALT; FILM-THICKNESS |
摘要: |
Superpave and Marshall mix designs using local aggregates were done to study the suitability of the Superpave mix design as compared with the Marshall mix design for low-volume roads, especially shoulders. The project site was Kansas Route 177 in northeast Kansas. Three locally available aggregates, crushed limestone and coarse and fine river sands, were used in this study. Five blends with varying proportions of coarse and fine river sands were selected. Mix samples were compacted in the Superpave gyratory compactor with the applicable number of gyrations and were compacted with the Marshall hammer by using 50 blows per face. Bulk densities of the compacted samples and maximum specific gravities of loose samples also were measured for each blend. The results show that the Superpave mix design for low-volume roads and shoulders results in lower estimated asphalt content than does the Marshall method. The required asphalt content increases as the proportion of coarse river sand increases in the mix. Superpave requirements for the voids filled with asphalt (VFA) for low-volume traffic, that is, less than 0.3 million equivalent single-axle loads, appeared to be too high. High asphalt film thicknesses were computed for the mixtures that did not meet the Superpave VFA requirements. Lowering the design number of gyrations for compaction of samples would result in increased asphalt requirement for the Superpave mixture with a given gradation. |
总页数: |
Transportation Research Record. 1998. (1609) pp44-50 (5 Fig., 8 Tab., 4 Ref.) |
报告类型: |
科技报告 |