详情

原文传递 Tension and Bending Testing of an Integral T-Cap for Stitched Composite Airframe Joints.

题名：	Tension and Bending Testing of an Integral T-Cap for Stitched Composite Airframe Joints.
作者：	Lovejoy, A. E.; Leone, F. A. J.
关键词：	Bending, Delaminating, Design analysis, Joints (junctions), Load tests, Loads (forces), Rods, Structural design, Tension, Blended-wing-body configurations, Fillets, Load testing machines, Stiffening, Structural failure, Webs (supports)
摘要：	The Pultruded Rod Stitched Efficient Unitized Structure (PRSEUS) is a structural concept that was developed by The Boeing Company to address the complex structural design aspects associated with a pressurized hybrid wing body aircraft configuration. An important design feature required for assembly is the integrally stitched T-cap, which provides connectivity of the corner (orthogonal) joint between adjacent panels. A series of tests were conducted on T-cap test articles, with and without a rod stiffener penetrating the T-cap web, under tension (pull-off) and bending loads. Three designs were tested, including the baseline design used in large-scale test articles. The baseline had only the manufacturing stitch row adjacent to the fillet at the base of the T-cap web. Two new designs added stitching rows to the T-cap web at either 0.5- or 1.0-inch spacing along the height of the web. Testing was conducted at NASA Langley Research Center to determine the behavior of the T-cap region resulting from the applied loading. Results show that stitching arrests the initial delamination failures so that the maximum strength capability exceeds the load at which the initial delaminations develop. However, it was seen that the added web stitching had very little effect on the initial delamination failure load, but actually decreased the initial delamination failure load for tension loading of test articles without a stiffener passing through the web. Additionally, the added web stitching only increased the maximum load capability by between 1% and 12.5%. The presence of the stiffener, however, did increase the initial and maximum loads for both tension and bending loading as compared to the stringerless baseline design. Based on the results of the few samples tested, the additional stitching in the T-cap web showed little advantage over the baseline design in terms of structural failure at the T-cap web/skin junction for the current test articles.
总页数：	Lovejoy, A. E.; Leone, F. A. J.
报告类型：	科技报告